Table of Contents
Advertisement
E2J70BD_EN.book Page 26 Friday, June 29, 2007 2:50 PM
This unit can receive the Hyper and Oscar
frequency bands.
• If "Skip" is set to "ON", select "Skip" using
[U \ D], then press [P]. Select "OFF" using
[U \ D], then press [L].
• If you want to decode scrambled signals, select
"Decoder" using [U \ D], then press [P]. Select
"ON" using [U \ D], then press [L].
• To store another channel, repeat steps
9
After completion, press [SETUP] to
exit.
To Skip a Preset Channel
ANALOG
You can set the unit to skip channels. You can no
longer receive or watch when you access channels
using [PROG. G / H].
1
Follow steps
1
(ANALOG)" on page 25.
2
Select "Position" using [U \ D], then
press [P].
3
Select the position number you wish
to skip using [the Number buttons]
or [U \ D], then press [L].
4
Select "Skip" using [U \ D], then
press [P].
5
Select "ON" using [U \ D], then
press [L].
• To skip another channel, repeat steps
6
Press [SETUP] to exit.
Move
ANALOG
You can replace two channels.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U \ D],
then press [ENTER/OK].
2
Select "Channel" using [U \ D],
then press [ENTER/OK].
3
Select "ANALOG Channel Setup"
using [U \ D], then press [ENTER/
OK].
4
Select "Move" using [U \ D], then
press [ENTER/OK].
5
Select the position number of which
you want to change the channel
using [U \ D], then press [ENTER/
OK].
You cannot select a position number where
"– – –" appears next to the number, because
"Skip" is set to "ON" for that position number.
26
EN
5
8
to
.
to
in "Manual Tuning
4
2
5
to
.
6
Move the channel to another position
number using [U \ D], then press
[ENTER/OK].
• To move another channel, repeat steps
7
Press [SETUP] to exit.
Auto Tuning (DVB)
DVB
You can programme the tuner to scan only the DVB
channels that you can receive in your area.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U \ D],
then press [ENTER/OK].
General Setting menu will appear.
2
Select "Channel" using [U \ D],
then press [ENTER/OK].
3
Select "DVB Channel Setup" using
[U \ D], then press [ENTER/OK].
4
Select "Auto Tuning" using [U \ D],
then press [ENTER/OK].
The unit will start storing channels available in
your area.
DVB Channel Setup
Edit Channels
Auto Tuning
Manual Tuning
Signal Information
The tuner scans and memorise all the active DVB
channels (TV / RADIO) in your area.
CHANNEL SEARCH
CHANNEL 22 – 482 MHz
TV 13
RADIO 0
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
BACK
• Press [GREEN] after Auto Tuning is completed,
then the lowest memorised DVB channel
appears on the screen, and you can use
[PROG. G / H] for the memorised DVB
channels.
• If you press [RETURN/BACK] or [RED] during
the scanning, the screen will return to the
previous displayed menu, and Auto Tuning will
be cancelled.
• If you press [SETUP] during the scanning, this
operation will stop and the lowest memorised
DVB channel will appear on the TV screen.
4
6
to
.
Advertisement
Table of Contents
