Toshiba RD-97DTKB Owner's Manual page 22

E2J70BD_EN.book Page 22 Friday, June 29, 2007 2:50 PM
Copyright protection system
To play back the digital video images of a DVD via an
HDMI connection, it is necessary that both the player
and the display device (or an AV amplifier) support a
copyright protection system called HDCP (high-
bandwidth digital content protection system). HDCP is
copy protection technology that comprises data
encryption and authentication of the connected AV
device. This unit supports HDCP. Please read the
operating instructions of your display device (or AV
amplifier) for more information.
* HDMI: High Definition Multimedia Interface
Note
• Because HDMI is an evolving technology, it is
possible that some devices with an HDMI input may
not operate properly with this unit.
• When using an HDCP-incompatible display device,
the image will not be viewed properly.
• Among the devices that support HDMI, some
devices can control other devices via the HDMI
connector; however, this unit cannot be controlled by
another device via the HDMI connector.
• The audio signals from the HDMI connector
(including the sampling frequency, the number of
channels and bit length) maybe limited by the device
that is connected.
• Among the monitors that support HDMI, some do
not support audio output (for example, projectors).
In connections with device such as this unit, audio
signals are not output from the HDMI output
connector.
• When this unit's HDMI connector is connected to a
DVI-D compatible monitor (HDCP compatible) with
an HDMI-DVI converter cable, the signals are output
in digital RGB.
• If the connected equipment is not compatible with
HDMI BITSTREAM, DTS sound will not be output.
• When the power failure occurs, or when you unplug
the unit, some problems in the HDMI setting might
occur.
Please check and set the HDMI setting again.
22
EN
Connecting to External Equipment
This unit has three input terminals which can be
selected using the input select button of the remote
control, AV1 or AV2 on the rear panel and AV3 on the
front panel. Be sure that all the units are switched off
before making connections.
Recording from a DVD player, Satellite Box
or other Audio-Video equipment with a Scart
output socket (AV2)
Scart cable (not supplied)
AV2 (DECODER)
IN
Y
DIGITAL COAXIAL
HDMI OUT
P B
/C B
ANALOG L
P
R
/C
R
OUT ANALOG R
AV2 (DECODER)
DVB-T ANALOG
AUDIO COMPONENT
ANTENNA
OUT VIDEO OUTPUT
Notes
• When you record a TV programme from a Satellite
Box, you must connect a Scart cable to AV2
(DECODER). (See page 45.)
• When AV2 is connected, the signal from the AV2 will
be output automatically. If you want to monitor the
signal from other input, you must press [DISPLAY]
first. Then, select the desired input to monitor with
[INPUT SELECT F].
Recording from a camcorder or other
Audio-Video equipment with no Scart output
socket (AV3)
If no S-Video input jack is available, connect to
VIDEO input jack on the front panel using an RCA
Video cable.
Change the setup when using S-VIDEO input jack.
(See page 47.)
When connecting a DV-camcorder, use DV input jack
of AV4 (Front) instead of S-VIDEO IN or VIDEO IN
jack.
AV3 (Front)
1080p 1080i 720p 576p/480p
STOP PLAY REC
AV3
S-VIDEO VIDEO L R DV IN
Audio
cable
S-Video cable
(not
(not supplied)
supplied)
S-VIDEO AUDIO
OUT OUT
Note
• When connecting an external device of monaural
output to this unit, use AUDIO L jack of AV3.
AV output
jack (Scart)
AV1 (TV)
DV cable
(4-pin)
(not
supplied)
DV OUT