Table of Contents
Advertisement
E2J70BD_EN.book Page 25 Friday, June 29, 2007 2:50 PM
Auto Tuning (ANALOG)
ANALOG
Programme the tuner to scan only the channels you
can receive in your area.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U \ D],
then press [ENTER/OK].
General Setting menu will appear.
2
Select "Channel" using [U \ D],
then press [ENTER/OK].
3
Select "ANALOG Channel Setup"
using [U \ D], then press
[ENTER/OK].
4
Select "Auto Tuning" using [U \ D],
then press [ENTER/OK].
The unit will start storing channels available in
your area.
ANALOG Channel Setup
Auto Tuning
Manual Tuning
Move
Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel
901-999 after it is scanned by this unit.
5
Press [SETUP] to exit.
You can select only the channels memorised in
this unit by using [PROG. G / H].
To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when this unit is in
any recording mode (normal recording, One-touch
Timer Recording or timer recording).
• Sorting of TV channels from 901 to 906 will be
performed automatically as follows.
901: BBC1
902: BBC2
904: CH4
905: CH5
• If you are using a satellite receiver, turn it on and
select SKY NEWS before commencing tuning.
Manual Tuning (ANALOG)
ANALOG
You can preset an analogue channel manually and
individually.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U \ D],
then press [ENTER/OK].
2
Select "Channel" using [U \ D],
then press [ENTER/OK].
3
Select "ANALOG Channel Setup"
using [U \ D], then press [ENTER/
OK].
4
Select "Manual Tuning" using
[U \ D], then press [ENTER/OK].
5
Select "Position" using [U \ D], then
press [P].
6
Select the position number you wish
to use using [the Number buttons] or
[U \ D], then press [L].
• You can select position number 901-999.
• With [the Number buttons], you only need to
7
Select "Channel" using [U \ D],
then press [P].
8
Press [U \ D] to start scanning.
• The tuner will begin to search up or down
903: ITV
906: SKY NEWS
• You can select a desired channel number using
• If this is the channel you want, press [L].
Manual Tuning
Position
901
Channel
1
Decoder
OFF
Skip
ON
enter the last 2 digit numbers.
automatically. When a channel is found, the unit
will stop searching and the picture will appear
on the TV screen.
[the Number buttons]. Refer to the following
Channel Plan table and press the three digits to
select the channel number.
(To select channel 4, press [0] first and then
press [0] and [4]. Or press [4] and then "– – 4"
appears and wait for 2 seconds.)
Channel Plan
CH Indication
TV Channel
01 – 10
IRA-IRJ, GAP
21 – 69
E21 – E69
74 – 78
X, Y, Z, Z+1, Z+2
80 – 99, 100
S1 – S20, GAP
121 – 141
S21 – S41
25
EN
Advertisement
Table of Contents
