Settings For External Equipment - Toshiba RD-97DTKB Owner's Manual

E2J70BD_EN.book Page 47 Friday, June 29, 2007 2:50 PM

Settings for External Equipment

Connection to External Equipment
Video
HDD HDD
D D VD-R DVD-RW VD-RW W
DVD+RW D D VD+R VD+RW W D D VD+R DVD+R VD+R
Connect the external equipment using either the input
jacks, AV1, AV2 (Rear) or AV3 (Front). However, for
AV3 jacks, you have to select S-VIDEO input or
VIDEO input jacks depending on the connected
devices.
Use a commercially available Scart, S-Video or Video
cable and an Audio cable for this connection.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U \ D],
then press [ENTER/OK].
2
Select "Video" using [U \ D], then
press [ENTER/OK].
3
Select "Select Video" using [U \ D],
then press [ENTER/OK].
4
Select the input jack type to be used
using [U \ D], then press
[ENTER/OK].
Select Video - AV3(Front)
Video In
S-Video In
• If you want to use VIDEO input jack
(Composite), select "Video In".
• If you want to use S-VIDEO input jack, select
"S-Video In".
5
Press [SETUP] to exit.
VR
DVD-RW DVD-RW DVD-R DVD-R
Recording from External Equipment
Video VR
HDD HDD
DVD-RW D D VD-R VD-RW W DVD-RW DVD-RW
DVD+RW D D VD+R VD+RW W D D VD+R DVD+R VD+R
Before recording from external equipment, see page
22 for connection instructions.
1
Turn the TV and the unit on, and
select the input of the TV to which
the unit is connected.
If you are recording to the HDD, press [HDD],
3
then proceed to step .
If you are recording to a disc, press [DVD].
2
Press [OPEN/CLOSE A] to open the
disc tray, then place the disc to
record on.
Press [OPEN/CLOSE A] again to
close the disc tray.
3
Select the input terminal to which the
external equipment is connected
(AV1, AV2, or AV3).
To use the input jacks on the rear of the unit,
select "AV1" or "AV2" position by pressing [INPUT
SELECT F] or [PROG. G / H].
To use the input jacks on the front of this unit,
select "AV3" position by pressing
[INPUT SELECT F] or [PROG. G / H].
4
Select a recording mode using
[REC MODE]. (See page 33.)
5
Press [I REC] on the unit to start
recording.
6
Press the [PLAY] button on the
external recording component.
7
Press [C STOP] on the unit to stop
recording.
Note
• During recording, if a signal other than PAL is
detected (such as NTSC), recording is paused.
• If you want to monitor the programme that you are
recording, make sure the device such as a Satellite
Box is powered off or press [DISPLAY] when it is
connected to AV2.
DVD-R DVD-R
47
EN