Table of Contents
Advertisement
Pressures
Natural Gas
20mbar.
Reassemble burner top, making sure it is reassembled in the
correct way on the burner body.
Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical Engineers
(I.E.E.) regulations and also the local electricity supply
company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch having a contact separation of at least 3mm in all
poles. This cooker must not be connected to an ordinary
domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (see fig.). Check that the links are correctly
fitted and that the terminal screws are tight. Secure the
mains cable using the cable clamp.
These appliances are of type X with regard to protection
against over heating of the surrounding surfaces.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances the
cooker circuit may need to be protected by fitting 100mA
device. This work should be carried out by a qualified
electrician.
Hotplate
Check each burner in turn. There is a flame safety device
that stops the flow of gas to the burner if the flame goes
Check the appliance is electrically safe and gas sound when you have finished.
LP Gas cookers
Butane
29mbar
Propane
37mbar
INSTALLATION
out. There is also a spark ignition system that works when
the knob is pressed in.
For each burner, push in and turn the knob to the solid
flame symbol ( ).
The igniter should spark and light the gas. Keep holding the
knob pressed in to let the gas through to the burner for few
seconds. If, when you let go of the control knob, the burner
goes out, the safety device has not held in. Turn the control
to the off position and wait one minute, then try again this
time holding in the control knob for slightly longer.
Turn off the burners.
Oven check
Set the clock to the time of day
When the clock is first connected the display will flash (
To set the clock to read the time of day turn and hold the
Timer knob to the clock symbol
turn the Adjusting knob left or right until the clock shows
the time of day. Remember this is a 24 hour clock. Let go
�
���
���
of the Timer knob and it will spring back to the vertical
oven manual setting.
Turn on the oven and check that the oven fan starts to turn
and that the oven starts to heat up.
Check that the oven light is working.
NB. The oven light bulb is not included in the guarantee.
Turn off the oven.
Fitting the plinths
The cooker is supplied with two stainless steel side panel
extensions, a black front plinth with stainless steel end feet
and a stainless front plinth trim plate.
Fitting the side extensions (optional)
If the installed height of the cooker is less than 910mm to
the hotplate surround, or the distance from the bottom
of the side panel to the floor is less than 60mm, the side
extension should not be fitted. If the cooker is installed
between 2 units the side extensions are not necessary.
29
) and (
) alternately.
and at the same time
Advertisement
Table of Contents
