Asko WMC67 P Series User Manual page 43

Table continued from last page
Error Error indication on the
display unit
E10 Water level sensor error
E11 Overflow
E12 Motor error / motor control
error
E23 Error while unlocking the door
E36 Error in UI** and PMCU
communication.
E37 PMCU/UI** software versions
are not compatible
E40 Voltage value out of range.
E41 The value of frequency out of
range.
E45 EADBS communication error.
Unevenly distributed laundry.
Unable to lock door
Warning Self-cleaning
program
Preparing to door unlocking.
(press INFO): Draining must
be performed. Wait for door
unlocking.
Water drain system alert
** UI = (User Interface)
What to do?
Turn the appliance OFF and then switch it again ON. Start
the program again. If the error reoccurs, call service
technician.
If there is water in the drum that exceeds a certain level, and
an error is reported on the display unit, the washing program
will be interrupted and water will be pumped out of the
washing machine. Restart the programme. If the error
reoccurs, call a service technician.
If there is water in the drum that exceeds a certain level, and
an error is reported on the display unit, while the washing
machine continues to add water, close the water tap and call
a service technician.
Restart the program; if the error reoccurs, call a service
technician.
Door is closed, but it cannot be unlocked. Turn off the washing
machine, then turn it back on. If the error reoccurs, call a
service technician. See instructions for opening the door
chapter on manual door opening.
Turn off the appliance and turn it back on. If the error
reoccurs, call a service technician.
Call a service technician.
Restart the program. If the error reoccurs, call a service
technician.
Restart the program. If the error reoccurs, call a service
technician.
Call service centre.
Manually distribute the laundry and run the spinning program.
Open and firmly close the door again to final position. If the
error reoccurs, call a service technician.
Message "Sterile Tube alert" is displayed every 40 completed
wash cycles. Use the self-cleaning program (DRUM
CLEANING); see STEP 5.
Wait for the process to finish. If no errors are shown after the
process, a new cycle can be run.
Alert about reduced water flow in the pumping stage. Please
check user manuals.
Errors what to do?
43