Settings - Asko WMC67 P Series User Manual

Settings

Only appliance owner/distributor may change the settings!
(owner/distributor should check Service manual)
On display
Max. RPM
Drain
Show temp
Change program
• Prewash
• Change temperature
• Change spin RPM
• Water Level
• Anti-crease
• Save program
Spin time
Temperature unit
Super rinse
Payment system
3D sensor
30
Setting
no Drain --> max. rpm
Valve/Drain
On/Off
On each program (some
settings cannot be set on some
programs)
On/Off
0 --> max
no Drain --> max. rpm
On/Off
On/Off
Override existing/Save as new
0 --> 300
°C/°F
On/Off
On/Off
On/Off
Description
Setting affect all programs
Setting of draining via valve or
pump, depending on the type of
appliance; in case of change, a
mechanical change on the
appliance is required.
In the Disinfection programs and
in the Special programs; this
means displaying the actual
measured temperature in the
drum.
By changing settings it is
possible to create and customize
your own program.
Program can be renamed!
°C/°F
Once the above changes are
done, you can save the program
as a new program or overwrite
an existing program.
At max. rpm in the Spinning
phase
Choose either °C or °F.
Additional rinses to the program
are added.
With enabled function payment
is requested, to be able to start
the program.