Planar Dome Q2 Reference Manual page 28

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Q2 Display
Check Package Contents
Identify Components
Position the Display
Desk Stand Features
INSTALLING THE DISPLAY
Install AX1 Controller
Connect Cables
Install Display Driver
Adjust Display Properties
OPERATING THE DISPLAY
Front-Panel Controls
Screen Adjustments
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
USB Connections
Power Management System
Driver Removal
Problem
Controller not performing optimally
Operating system warns that the controller
is not configured properly
Dual displays not functioning
Address and interrupt conflicts
Dome Q2 Display
Possible Solution
Check the Information tab on the Display Properties dialog box.
Check the driver installation and make sure that the software is correctly loaded for
your operating system.
Reinstall the driver.
Make sure both displays are securely connected to the controller.
Make sure both displays are on before you start the computer.
Check the setting on the Display Properties dialog box. Make sure the check box for
Extend my Windows desktop onto this monitor is selected.
Ensure that the I/O and memory addresses reserved for the controller are not used by
other hardware devices.
The integrated onboard VGA controller uses the following addresses (hex):
I/O Addresses:
Standard VGA I/O: 3B0-3DF
Memory Addresses:
Video RAM: A000-BFFF
Video ROM: C000-C7FF
There may be problems if your controller does not receive an interrupt or if a system interrupt
is used for more than one device.
Check the system configuration utility of your operating system for the interrupt assignments.
20