Displaying The Remaining Operating Time Of The Rechargeable Battery; Using The Charging Reminder Function - Sennheiser Set 860 Instruction Manual

Displaying the remaining operating time of the
rechargeable battery
When you switch the stethoset receiver on, the
displays the remaining operating time/charge status.
Battery LED
To indicate that the operating time is decreasing, each LED
segment slowly dims before it goes off completely.
If the actual operating time differs widely from the specified
values, the rechargeable battery is probably exhausted and
should be replaced. Information on the rechargeable battery
can be found on page 31.
The display of the remaining operating time can be set so
that it automatically switches off after 30 seconds (see
page 36).
If more than one stethoset receiver is connected to the
transmitter, the remaining operating time/charge status
cannot be displayed.

Using the charging reminder function

When the stethoset receiver is switched off and the transmit-
ter automatically switches off (standby mode), the
LED will flash back and forth for 10 minutes to remind you
to charge the stethoset receiver.
b
Charge the stethoset receiver by placing it into the trans-
mitter's charging compartment (see page 15).
The LED stops flashing and the charging process starts.
You can also switch off the charging reminder function
(see page 36).
Putting the Set 860 into operation
Meaning
Rechargeable bat-
Battery
LED tery is empty;
flashes slowly recharge the
rechargeable battery
st
approx. 6 hours of
1 LED seg-
operating time
ment lit
st nd
approx. 12 hours of
1 + 2 LED
operating time
segment lit
All LED seg- approx. 18 hours of
ments lit operating time
Battery
LED
Battery
Set 860 | 17