Section 8: Troubleshooting Guide - Taylor SLIM7 Operator's Manual

Section 8
Problem
1. Soft lock message
appears on display.
2. Hard lock message
appears on display.
3. No control panel
functions with machine
connected to the power
supply.
4. Machine makes a
squealing noise
5. No product is being
dispensed
Troubleshooting Guide
Table 8-1
Probable Cause
a. More than 24 hours since the last
Heat cycle.
b. The freezer was not in the Auto or
Standby mode when the Heat
cycle was programmed to start.
c. The hopper agitator is not installed.
d. There was a power failure.
a. Brush-cleaning interval exceeded.
a. Circuit breaker OFF or blown fuse.
b. Blown main board fuses.
a. Starved barrel.
a. Low on mix. The LEVEL message
is displayed.
b. Machine not in Auto mode.
c. Beater motor is off during over
temperature. The message
appears on the display.
Model 0736
Troubleshooting Guide
Remedy
a. The freezer must go through a Heat
cycle every 24 hours. The freezer
must now be disassembled and
brush-cleaned or placed in a Heat
cycle.
b. The freezer must be in the Auto or
Standby mode. The freezer must now
be disassembled and brush-cleaned
or placed in a Heat cycle.
c. The hopper agitator must be cleaned
and installed before starting the Heat
cycle. The freezer must now be
disassembled and brush cleaned or
placed in a Heat cycle.
d. Check the Event History fault
messages. Disassemble and 
brush-clean, or initiate a Heat
Treatment Cycle.
a. The freezer must be disassembled
and brush-cleaned within 24 hours
when the counter indicates one day
remaining.
a. Turn the breaker ON or replace the
fuse.
b. Call a service technician.
a. Remove, clean, and re-install the
pump.
b. Check, and if necessary, change the
position of the regulator tube on
position for greater liquid flow (turn it
to the left).
a. Add mix to the hopper.
b. Select Auto and allow machine to
cycle off before drawing product.
c. Press the STOP button and wait
5 minutes. Restart the machine in
Auto mode.
Page
Ref.
- - -
5-3 and
6-10
5-3 and
6-10
5-7
6-10
- - -
- - -
6-4
- - -
8
- - -
5-2
5-2
8-1