Section 3: Safety; Installer Information; To Operate Safely - Taylor SLIM7 Operator's Manual

Section 3

Installer Information

We at the Taylor Company are concerned about the
safety of the operator when he or she comes into contact
with the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety features
to protect both you and the service technician. As an
example, warning labels have been attached to the
machine to point out safety precautions to the operator.
DANGER! Failure to adhere to the following
safety precautions may result in severe personal injury or
death. Failure to comply with these warnings may also
damage the machine and/or its components. Such
damage may require component replacement and
service repair expenses.

To Operate Safely

NOTICE! DO NOT operate the machine
without reading the Operator Manual. Failure to follow
this instruction may result in machine damage, poor
machine performance, health hazards, or personal injury.
WARNING! Avoid injury.
• DO NOT allow untrained personnel to operate
this machine.
• DO NOT put objects or fingers in the door
spout.
• DO NOT operate the machine unless all service
panels and access doors are restrained with
screws.
• DO NOT remove the machine door or beater
assembly unless the control switches are in the
OFF position.
Safety
Failure to follow these instructions may result in severe
personal injury from hazardous moving parts.
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers in the door
spout. Failure to follow this instruction may
result in contaminated product or personal injury
from blade contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp and may cause injury.
IMPORTANT! Access to the service area of
the machine is restricted to persons having knowledge
and practical experience with the machine, in particular
as far as safety and hygiene are concerned.
CAUTION! This machine must be installed on
a level surface to avoid the hazard of tipping. Extreme
care should be taken in moving this machine for any
reason. Two or more persons are required to safely move
this machine. Failure to comply may result in personal
injury or machine damage.
WARNING! Avoid injury.
• DO NOT operate the machine unless it is
properly grounded.
• DO NOT operate machine with larger fuses
than specified on the data label.
• All repairs must be performed by an authorized
Taylor service technician.
• The main power supplies to machine must be
disconnected prior to performing repairs.
Model 0736
Safety
3
3-1