Table of Contents
Advertisement
de Set up and connect
WARNING
Risk of injury!
The device can tip over when
operated on a base.
▶
Before putting the device into operation, it is
essential to secure the feet of the device on a
base with the retaining tabs → Page 29 of the
manufacturer.
CAUTION!
The device may contain residual
water. If you tilt the device over 40 °,
this residual water can run out.
Carefully tilt the device.
▶
Installation site
base
Wooden beam ceiling
Kitchenette
14th
conditions
The device with
Retaining tabs
→
Page 29 loading
consolidate.
Place the device
on a water
standing wooden
plate (thickness
at least 30 mm)
put up the
firmly to the floor
is screwed.
The device only
under through
walking working
set up the plate,
which are firmly
attached to the
ken connected
is. Required
Niche width:
60 cm.
Installation site
On a wall
CAUTION!
Residual water can freeze. Freezing
residual water can damage the device
and frozen hoses can burst.
▶ Do not set up the device in areas
where there is a risk of frost or
outdoors.
4.4 Remove the transport
locks
The device is secured for transport
with transport locks on the rear of
the device.
Notice: Keep the screws of the
transport locks and the sleeves for
later transport → Page 47 on.
Pull the hoses out of the holders.
1.
conditions
No hoses
between wall
and device on
clamp.
Advertisement
Table of Contents
