Table of Contents
Advertisement
06/03/06 13:49:24 3CMCJ600_097
5.
Align the chain adjuster index marks ( )
with the corresponding scale ( )
graduations on both sides of the
swingarm.
Both left and right marks should
correspond. If the axle is misaligned, turn
the left or right adjusting bolt until the
ma r k s co r r e s po n d o n t h e s c a le
graduation on the swingarm and recheck
chain slack.
6.
Tighten and torque the rear axle nut.
Axle nut torque:
113 N·m (11.5 kgf·m , 83 lbf·ft)
7.
Tighten the adjusting bolts lightly by
turning it counterclockwise, then tighten
the lock nuts by holding the adjusting
bolts with a spanner.
8.
Recheck drive chain slack.
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper as-
sembly.
4
5
Damage to the bottom part of the
frame may be caused by excessive
drive chain slack of more than:
50 mm (2.0 in)
91
Advertisement
Table of Contents
