06/03/06 13:49:57 3CMCJ600_103
WHEEL REMOVAL
(Refer to the maintenance precautions on
page
77
).
This motorcycle is equipped with a side
stand only. Therefore, if front or rear
wheel removal is required, it will be
necessary to raise the center of the
motorcycle with a jack or other firm
support. If none is available, see your
Honda dealer for this service.
Front Wheel Removal
1.
Raise the front wheel off the ground by
placing a support block under the engine.
2.
Remove the right and left caliper
assembly (1) from the fork leg by
removing the fixing bolts (2).
To avoid damage to the brake hose,
support the caliper assembly so that
it doesn't hang from the hose. Do not
twist the brake hose.
Do not depress the brake lever when the
caliper assembly is removed. The caliper
piston will be forced out of the cylinder
with subsequent loss of brake fluid. If this
occurs, servicing of the brake system will
be necessary. See your Honda dealer for
this service.
(2)
(1)
(1) Brake caliper assembly
(2) Fixing bolts
97