Table of Contents
Advertisement
06/03/06 13:48:19 3CMCJ600_087
6.
Check that the sealing washer on the
drain plug is in good condition and install
the plug. Replace the sealing washer
every other time the oil is changed, or
each time if necessary.
Oil Drain Plug Torque:
29 N·m (3.0 kgf·m , 22 lbf·ft)
7.
Fill the crankcase with the recommended
grade oil; approximately:
3.7 (3.9 US qt , 3.3 Imp qt)
8.
Install the oil filler cap.
9.
Install the middle fairing and the lower
fairing.
10.
Start the engine and let it idle for 2 3
minutes.
11.
Several minutes after stopping the engine,
check that the oil level is at the upper
level mark in the inspection window with
the motorcycle upright on firm, level
ground. Make sure there are no oil leaks.
When running in very dusty conditions,
oil changes should be performed more
f requent ly t han specif ied in the
maintenance schedule.
Please dispose of used engine oil in a
manner that is compatible with the
environment. We suggest you take it in a
sealed container to your local recycling
center or service station for reclamation.
Do not throw it in the rubbish or pour it
on the ground or down a drain.
−
Used engine oil may cause skin can-
cer if repeatedly left in contact with
the skin f or prolonged periods.
Although this is unlikely unless you
handle used oil on a daily basis, it is
still advisable to thoroughly wash
your hands with soap and water as
soon as possible after handling used
oil.
81
Advertisement
Table of Contents
