Table of Contents
Advertisement
06/03/06 13:50:22 3CMCJ600_107
Installation Note:
To install the rear wheel, reverse the
removal procedure.
Make sure that the slot (8) on the
swingarm (9) is located in the lug (10) in
the brake caliper.
Tighten the axle nut to:
113 N·m (11.5 kgf·m , 83 lbf·ft)
Adjust the drive chain
When installing the wheel, carefully
fit the brake disc between the brake
pads to avoid damaging the pads.
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper as-
sembly. Improper assembly may lead
to loss of braking capacity.
(page 88).
(9)
(8) Slot
(9) Swingarm
(10)
(8)
(10)Lug
101
Advertisement
Table of Contents
