Memory Upgrade - Oki MC560 User Manual
Hide thumbs
Also See for MC560:
- Quick setup (2 pages) ,
- Handy reference (165 pages) ,
- Service & troubleshooting manual (91 pages)
Table of Contents
Advertisement
M
EMORY UPGRADE
This section explains how to install additional RAM memory into your MFP as a memory
upgrade.
The model comes equipped with 256MB of main memory.This can be upgraded with an
additional memory board containing either 256MB or 512MB, giving a total memory
capacity of either 512MB or 768MB maximum.
1.
Switch the MFP off and disconnect the AC power cable.
2.
Pull open the access panel on the side of the machine.
3.
Carefully remove the new memory board from its wrapping. Try to handle the board
only by its short edges, avoiding contact with any metal parts as far as possible. In
particular, avoid touching the edge connector.
4.
Notice that the memory board has a small cutout in the edge connector, which is
closer to one end than the other.
5.
Identify the RAM expansion slot (1) in the machine.
6.
Hold the new memory board by its short edges, so that the edge connector faces in
towards the RAM expansion slot, and the small cutout is closer to the bottom of the
machine.
7.
Gently push the board into the RAM expansion slot until it latches in and will not go
any further.
Installing upgrades > 95
Advertisement
Table of Contents
