JUKI DDL-900B Instruction Manual page 40

Output function list
Function Abbre-
code viation
0 noP No function
1 TrM Thread trimming output
2 WiP Thread wiper output
3 TL Thread release output
4 FL Presser lifter output
5 bT Reverse feed stitching output
6 EbT EBT cancel monitor output
7 SEbT Reverse feed stitching at start/end
cancel monitor output
8 AUbT Sewing start/end cancellation/addi-
tion monitor output
9 SSTA Sewing machine stop state output
10 CooL Needle cooler output
11 bUZ Buzzer output
12 LSWo Revolution command output
Output function connector
Connector No. Pin No. Display No.
CN22 3
CN22 7
CN22 14
Function item
(Standard setting)
Output of thread trimming signal
Output of thread wiper signal
Output of thread release signal
Output of presser lifting signal
Output of reverse feed stitching signal
State of one time cancel of reverse feed stitching at end func-
tion is output.
State of cancel of reverse feed stitching at start/end is output.
State of cancel or addition of automatic reverse feed stitching
is output.
Sewing machine stop state is output.
Output for needle cooler
It is output when the bobbin counter set value has been ex-
ceeded, an error has occurred or the bobbin thread remaining
amount is detected.
Revolution demanding command state is output.
Function
o.1 Reverse feed stitching output
o.2 Thread trimming output
o.3 Revolution request input
– 38 –
Remarks
Initial value of No. 12
bT
TrM
LSWo