JUKI DDL-900B Instruction Manual page 39

Input function list
Function Abbre-
code viation
0 noP No function
1 HS Needle up / down compensating
stitching
2 bHS Back compensating stitching
3 EbT Function of canceling once reverse
feed stitching at the end of sewing
4 TSW Thread trimming function
5 FL Presser foot lifting function
6 oHS One stitch compensating stitching
7 SEbT Function of cancel of reverse feed
stitching at start/end
8 Ed Material edge sensor input
9 LinH Function of prohibiting depressing
front part of pedal
10 TinH Function of prohibiting thread trim-
ming output
11 LSSW Low speed command input
12 HSSW High speed command input
13 USW Needle lifting function
14 bT Reverse feed stitching switch input Reverse feed stitching is output as long as the switch is held
15 SoFT Soft start switch input
16 oSSW One-shot speed command switch
input
17 bKoS Backward one-shot speed com-
mand switch input
18 SFSW Safety switch input
19 AUbT Automatic reverse feed stitching
cancellation/addition switch
20 CUnT Sewing counter input
Input function connectors
Connector No. Pin No. Display No.
CN22 5
CN20 7
CN20 11
CN20 9
CN20 5
Function item
(Standard setting)
Every time the switch is pressed, normal feed stitching by half
stitch is performed. (Same operation as that of up / down com-
pensating stitching switch on the panel.)
Reverse feed stitching is performed at low speed while the
switch is held pressing.
By depressing the back part of the pedal after pressing the
switch, operation of reverse feed stitching is canceled once.
This function is actuated as the thread trimming switch.
This function is actuated as the foot lifter switch.
Every time the switch is pressed, one stitch stitching operation
is executed.
By operating the optional switch, ineffective/effective can be
alternately changed over.
This function works as the input signal of material edge sensor.
Rotation by pedal is prohibited.
Output of thread trimming is prohibited.
This function works as low speed switch for standing sewing
machine.
This function works as high speed switch for standing sewing
machine.
UP stop motion is performed when switch is pressed during
DOWN stop.
pressed.
The speed of stitch is limited to the predetermined soft-start
speed as long as the switch is held pressed.
This function works as one-shot speed command as long as
the switch is pressed.
Reverse feed stitching is performed in accordance with the
one-shot speed command as long as the switch is held
pressed.
Rotation is prohibited.
Every time the switch is pressed, reverse feed stitching at sew-
ing start or reverse feed stitching at sewing end is canceled or
added.
Every time the switch is pressed, the sewing counter value is
increased.
Function
i.1 Reverse feed stitching switch input
i.2 Thread trimming switch input
i.3 Low-speed revolution switch input
i.4 High-speed revolution switch input
i.5 Presser foot lifting switch input
– 37 –
Remarks
Initial value of No. 12
bT
TSW
LSSW
HSSW
FL