Installation Types; Wall Mounted; Shelf Mounted; Feature Wall - Rinnai ES750 Operation & Installation Manual

The manufacturer does not accept any liability for any injuries or damages that may occur due
to improper handling or installation. Ensure that the wall where the appliance is to be installed
and any wall fixings used are sufficiently strong enough to hold the weight of the appliance.
IMPORTANT
The appliance weight can be found printed on the packaging.
Plasterboard alone is not considered a structural material and it is not recommended to rely solely on plasterboard
fittings to support the weight of the appliance.
If the appliance or any structure linked to the appliance is to be fitted to a wall with a timber frame construction,
adequate wooden supporting members must be fitted using appropriate fixings. If this is not possible then steps
must be taken to strengthen the wall before installation.

INSTALLATION TYPES

Wall Mounted

The appliance is supplied with a wall bracket which
is secured to the rear of the appliance.
Step 1.
Remove the bracket from the rear of the appliance,
place the bracket in the desired position ensuring it
is level, mark the fixing points and use appropriate
fixings to secure to the wall.
Step 2.
Attach the bottom mounting brackets to the appliance
using x4 ST4 screws (see Figure 15). The appliance
then can be lifted on to the wall bracket to enable
the bottom bracket fixing points to be marked on the
wall. Then use suitable fixings to secure the bottom
mounting brackets to the wall.
See details of the weight of the
appliance in the technical information
to help determine the correct fixtures.
NOTE

Shelf Mounted

The appliance can be fitted using the shelf support
brackets. Refer to Figure 16. The brackets can
be adjusted up or down to suit a range of shelf
material thickness from 15-24mm. Once the correct
thickness has been set, carefully place the unit onto
the shelf.

Feature Wall

Ensure that the stud wall has a supporting header
– the weight of the finished wall should not rest on
the top of the appliance. The base of the stud work
must be able to take the full weight of the appliance.
The 4 small mounting brackets can be fitted to the
appliance as shown in Figure 17 for securing to a
timber frame.
Rinnai
Figure 15.
Figure 16.
Figure 17.
17
INSTALLATION
Electric Fire Heater OIM – Issue 1