HD250i Direct Flueing - Kit / Important
Direct Flueing - Kit Components
Flue Terminal
Chamber
Screw Kit (in actual kit, screw components are packaged in a clear plastic roll pack)
Tapping Screws (ø 3.8 x L32)
Screw (M4)
Trim Nut (M4)
Important Installation Notes
•
The components of this flueing system CAN NOT BE CUT, use telescopic components to achieve the
required length
•
Ensure positioning of the flue terminal and flue installation comply with NZS:5261. The flue
products can reach temperatures above 200
•
Flue must be supported and be independent of the appliance
•
Ensure the appliance can be removed without causing movement or displacement of the flue
•
Flue components are self-locking
•
The O-Rings in all the components are pre-greased, ensure they are not damaged when joining
•
When preparing the wall penetration, cover flue spigot to prevent debris from entering the
appliance
Before Installation
•
Wall hole diameter is Ø75mm or greater and is secure
•
That there is a 2
angled fall to the flue terminal
o
•
Length of sleeve tube has been checked, wall thickness can be 150 - 250mm thick
•
Distance to surroundings of the flue terminal as per NZS:5261
Rinnai New Zealand
Sleeve
Butterfly Nuts (M5)
Screw Plugs (#10)
C.
o
3
Condensate Proof Cover
HD250i Flueing Installation: 0-07