Table of Contents
Advertisement
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code to any number from 00 to 99.
To change the setting:
Using the telephone base:
Press the MENU softkey when the telephone base is not in use.
1.
Press the SELECT softkey to select Answering sys.
2.
3.
Press
/
or
CID
2, then press the SELECT softkey. The corresponding
icon,
or
1
/
.
Press
or
CID
press the SELECT softkey.
/
5.
Press
or
CID
press the SELECT softkey.
6.
Use the dialing keys (0-9) to enter the code to any
number from 00 to 99. Press CANCEL to delete
a digit.
Press the SET softkey to confirm your setting or press
7.
CANCEL to exit to the previous menu without making
any changes.
Using the handset:
Press the MENU softkey when the handset is not in use.
1.
Press the SELECT softkey to select ANSWERING SYS.
2.
3.
Press
or
press the SELECT softkey. The corresponding icon,
1
or
, flashes on the screen.
2
.
Press
or
SELECT softkey.
5.
Press
or
SELECT softkey.
6.
Use the dialing keys to enter the code to any number
from 00 to 99. Press OFF to delete a digit.
Then press the SET softkey to confirm your setting or
7.
press the BACK softkey to exit to the previous menu
without making any changes.
If you change the remote access code setting on either Mailbox 1 or
Mailbox 2, it applies to both mailboxes in your answering system.
/
to select Mailbox 1 or Mailbox
DIR
flashes on the screen.
2,
/
to select Ans sys setup, then
DIR
/
to select Remote code, then
DIR
to select Mailbox 1 or Mailbox 2, then
to select Ans sys setup, then press the
to select Remote code, then press the
28
1
# of rings
Remote code
Msg alert tone
SELECT
1
REMOTE CODE
__
SET
1
ANS SYS SETUP
#
of rings
Remote code
Msg alert tone
BACK
SELECT
1
REMOTE CODE
__
BACK
SET
Advertisement
Table of Contents
