Remote Access; Set Remote Access Code - VTech DS6291 User Manual

Remote access

A two-digit security code is required to
access the answering system remotely
from any touch-tone telephone. The
preset code is 19. You can use this
preset code, or set your own.
1. Dial your telephone number from any
touch-tone telephone.
2. When the system plays your
announcement, enter the two-digit
security code.
3. You can enter one of the following
remote commands.
Command
1
Play all messages.
2
Play new messages.
3
Delete the current
message (during
playback).
33
Delete all old messages.
4
Repeat the current
message (during
playback).
5
Stop.
*5
Hear a list of remote
commands.
6
Skip to the next message
(during playback).
*7
Record a new
announcement.
8
End the call.
0
Turn the answering
system on or off.
Hang up or press 8 to end the call.
4.
NOTES
• If you do not press any keys after you
enter the remote access code, all new
messages play. If there are no new
messages, all old messages play.
Description
• Once the new messages have played,
the telephone announces the help menu
options. If you do not press any key within
20 seconds, the remote access call
automatically disconnects.
• When the answering system memory is
full, the telephone announces,
"Memory is full. Enter the remote access
code."

Set remote access code

A two-digit security code is required to
access the answering system remotely
from any touch-tone telephone. The
preset code is 19. You can set the code
from 00 to 99.
1. When the handset is in idle mode,
MENU
press
2. Press or
CALLER ID /
on the telephone base to scroll to
Answering sys, then press SELECT.
3. Press or
CALLER ID /
the telephone base to scroll to Ans
sys setup, then press
4. Press or
CALLER ID /
on the telephone base to scroll to
Remote code, then press SELECT.
5. Use the dialing keys to enter a
digit number. Press
backspace and delete a digit.
SAVE
6. Press
hear a confirmation tone.
53
to enter the main menu.
on the handset, or
or PHONEBOOK /
on the handset, or
or PHONEBOOK /
SELECT
on the handset, or
or PHONEBOOK /
/DELETE to
MUTE
to save the setting. You
on
two-