Fisher & Paykel OB60SD Single User Manual page 11

Replace shelving in your preferred positions
To replace the wire shelf:
Check the guard rail (as shown) to make sure
l
the shelf is the right way up.
Slide it horizontally back along the side racks
l
ensuring it is level and the stop notch is facing down.
Replacing the wire shelf
To replace a full extension sliding shelf
Position the shelf so that it is level, with the front bar toward you (as shown).
l
Check the guard rail (as shown) to ensure the shelf is the right way up.
l
Ensure the sliding frame is not extended.
l
Position the shelf on top of the side racks, so the rear shelf tag at the back of the sliding
l
frame rests behind the side rack wire (as shown).
IMPORTANT!
Ensure the sliding shelf is positioned on top of the side rack wires rather than
between them.
Push the sliding shelf all the way to the back of the oven, until the front shelf tag drops
l
into place behind the side rack wire.
We recommend placing the sliding shelves on position 2 or 4.
To prevent the tags from lifting off the side racks, take care to slide the shelves
forward horizontally.
FIRST USE
Stop Notch
Guard
rail
Front bar
Front
shelf tag
Shelf positions
6
5
4
3
2
1
Replacing the sliding shelves
11