SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS WARNING! Electrical shock hazard To avoid hazard, follow these instructions carefully Before carrying out any work on the ● ● before installing or using this appliance. electrical section of the appliance, it must be Please make this information available to the person disconnected from the mains electricity supply.
PARTS SUPPLIED Screws (2) Metal side shelves fixing nut (2) PRIOR TO INSTALLATION the benchtop and oven cavity are square and level, and are the required dimensions. ● ● the installation will comply with all clearance requirements and applicable standards and regulations. ●...
If using the lower trim kit accessory, you will need to install this BEFORE installing the appliance. Refer to the instructions packed with the lower trim kit. OB60NC MODELS OB60SC MODELS OB60SD MODELS PRODUCT DIMENSIONS Overall height of product (with lower trim kit fitted)
16-20 mm Electrical supply FLUSH INSTALL 16-20 mm 2 mm SIDE OB60NC MODELS OB60SC MODELS OB60SD MODELS CABINETRY DIMENSIONS Minimum inside width of cavity Overall width of cabinetry Minimum inside height of cavity (with lower trim kit fitted) Overall height of cabinetry...
Page 6
DISCARD PACKAGING RESPONSIBLY Oven may vary Remove the accessories box from the top of the oven and set aside. Recycle responsibly...
FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER Make sure the oven is level and securely fitted to the cabinetry. Check the lower trim is undamaged. Open the oven door slowly until it is fully open and check there is adequate clearance between the bottom of the door and the lower trim. This is to ensure correct air circulation.