Xerox WorkCentre EC7856 User Manual page 265

Print-Quality Problems and Solutions
Use the following table to find solutions to print-quality problems.
Note: To print procedures on resolving print-quality problems, at the printer control panel, press the
Machine Status button. Then touch Machine Information > Information Pages > Troubleshooting
Print Quality Page > Print.
Problem
Smears, Smudges, and Streaks
Dark or light marks appear on your
output.
Repeating Spots or Lines
Spot or lines appear at regular intervals on
the prints.
Colors Look Wrong
Colors are off or look drastically wrong.
Solution
Run a print job consisting of several blank pages through the printer to
remove toner accumulated on the fuser.
If the problem persists, print the test pages to help determine which
component is causing the image-quality problem.
• If the defect occurs in one color only, replace the corresponding imaging
unit.
• If the defect occurs in all colors and is visible on all the test pages, replace
the fuser.
1. To identify the part of the printer that is causing the problem, print the
Repeating Defects page. At the control panel, press Machine Status, then
touch Tools > Troubleshooting > Support Pages > Repeating Defects Page
> Print.
2. To identify the part responsible for the repeating spots or lines, follow the
instructions on the Repeating Defects page.
3. To correct the problem, replace the printer part identified on the
Repeating Defects page.
1. Verify that the printer is on a solid, level, and flat surface.
2. Perform the Calibrate Color procedure. At the control panel, press
Machine Status, then touch Tools > Troubleshooting > Calibration > Print
Calibration > Next, then follow the instructions.
Xerox ® WorkCentre ® EC7836/EC7856 Color Multifunction Printer
Troubleshooting
265
User Guide