Installing Graphics (Gpu) Cards - Supero SUPERSERVER 2027GR-TR2 User Manual

Installing Graphics (GPU) Cards

The chassis supports four GPU cards, which are mounted in brackets to fi t into the
PCI-E 3.0 slots at the front of the chassis. NVIDIA Kepler K10/K20/K40 GPUs are
supported. The GPU cards may be preinstalled, the procedure below is provided
for when a GPU card needs to be replaced. See NVIDIA's web site for more details
on the K10/K20/K40 GPU specifi cations.
Installing Graphics Cards
1. Identify the left and right brackets and graphics cards as illustrated below.
2. Insert the graphics cards into the brackets, aligning the mounting holes in the
cards with those in the brackets.
3. Secure each card to the bracket using the screws that are included for this
purpose.
4. Carefullly position each bracket in the chassis as illustrated, aligning the four
mounting holes in the top and side of each bracket with the corresponding
mounting holes in the chassis. Pay attention to the airfl ow arrows to install
each card into the correct side of the chassis
5. Secure the bracket to the chassis by using the screws provided.
6. After a GPU card is installed, you must connect it to one of the following
power headers on the serverboard: JPW3, JPW4, JPW5, JPW6, JPW7 or
JPW8.
Figure 6-15. GPU Airfl ow Block Diagram
Power Supply
AIR
Unused
CPU1
6-13
Chapter 6: Advanced Chassis Setup
Slot 3, 4 (to CPU2)
GPU Airflow: left to right
Tesla:
K10: (SKU-200): 900-22055-0010-000
GRID:
K2 (SKU-550): 900-52055-0010-000
K520 (SKU-050): 900-12055-0010-000
K340 (SKU-000): 900-12400-0010-000
CPU2
Slot 1, 2 (to CPU1)
GPU Airflow: right to left
Tesla:
K10: (SKU-202): 900-22055-0020-000
GRID:
K2 (SKU-552): 900-52055-0020-000
K520 (SKU-052): 900-12055-0020-000
K340 (SKU-002): 900-12400-0020-000
AIR