Nic1; Nic2; Information Led - Supero SUPERSERVER 2027GR-TR2 User Manual

NIC1

Indicates network activity on GLAN1 when fl ashing.

NIC2

Indicates network activity on GLAN2 when fl ashing.

Information LED

This LED will be solid blue when the UID function has been activated. When this
LED fl ashes red, it indicates a fan failure. When red continuously it indicates an
overheat condition, which may be caused by cables obstructing the airfl ow in the
system or the ambient room temperature being too warm. Check the routing of
the cables and make sure all fans are present and operating normally. You should
also check to make sure that the chassis covers are installed. Finally, verify that
the heatsinks are installed properly (see Chapter 5). This LED will remain fl ashing
or on as long as the indicated condition exists.
State
Continuously On (Red)
Fast Blinking Red (1 Hz)
Slow Blinking Red (.25 Hz)
Solid Blue
Blinking Blue
Note: deactivating the UID LED must be performed in the same way it was activated.
(If the UID LED was activated via IPMI, you can only turn the LED off via IPMI and
not with the UID button.)
Information LED States
Indication
An overheat condition has occured.
Fan Failure
Power Fail
Local UID button has been activated.
IPM/Remote UID has been activated
3-3
Chapter 3: System Interface