Stanley IK900 Instruction Manual page 2

Thank you for purchasing a STANLEY appliance.
Please read this manual carefully and keep it for future reference.
* All our products fulfil the requirements of the Construction Products Directive (Directive 89/106/EEC) and have been approved
with the CE conformity mark;
* The Pellet Burning Free Standing Fires are designed according to EN 14785:2008 Standards
* STANLEY disclaims any responsibility for damages to the unit if installed by non-qualified personnel;
* STANLEY is not responsible for any damage to units not installed and used in compliance to the instructions included in this
manual;
* All local regulations, including but not limited to national and European standards, must be observed when installing, operating
and servicing the unit;
* Whenever you need assistance, you should contact the supplier or installer of your equipment. You should provide the serial
number of your stove that is located on the nameplate on the back of the equipment , the nameplate is located on the right hand
side ,but can only be seen when the products is withdrawn from the opening. Disconnect electrical supply prior to viewing serial
withdrawing the product.
*The technical service must be performed by the unit Installer or Supplier, except on situations where the assessment performed
by the installer or service engineer determines that STANLEY should be contacted, if required.
Contacts for technical support:
www.waterfordstanley.com
service@waterfordstanley.com
1