Stanley Erin Installation And Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Stanley Manuals
  4. Stove
  5. Erin
  6. Installation and operating instructions manual

Stanley Erin Installation And Operating Instructions Manual

Non boiler solid fuel stove
Hide thumbs Also See for Erin:
Table of Contents

Advertisement

Quick Links

PLEASE RETAIN
Erin
Non Boiler Solid Fuel Stove
INSTALLATION AND OPERATING INSTRUCTIONS
This appliance is hot while in operation and retains its heat for a long period of time after use.
Children, aged or infirm persons should be supervised at all times and should not be allowed to touch
the hot working surfaces while in use or until the appliance has thoroughly cooled.
When using the stove in situations where children, aged and/or infirm persons are present a fireguard
must be used to prevent accidental contact with the stove. The fireguard should be manufactured in
BS 8423:2010.
accordance with

Advertisement

Table of Contents
loading

Related Manuals for Stanley Erin

Summary of Contents for Stanley Erin

  • Page 1 PLEASE RETAIN Erin Non Boiler Solid Fuel Stove INSTALLATION AND OPERATING INSTRUCTIONS This appliance is hot while in operation and retains its heat for a long period of time after use. Children, aged or infirm persons should be supervised at all times and should not be allowed to touch the hot working surfaces while in use or until the appliance has thoroughly cooled.

  • Page 2: Table Of Contents

    Stanley Solid Fuel Stove Warranty ........

  • Page 3: Stanley Solid Fuel Stove Warranty

    All warranty claims must be reported to the Waterford Stanley Service Department and must be submitted with the prod- uct serial number (located on the front casting), date of purchase, proof of purchase (if requested) and details of the specific nature of the problem.

  • Page 4: Installation Checklist

    INSTALLATION CHECK LIST Tick Flue System 1. Minimum Flue Height of 4.6 metres (15 feet). 2. Appliance should be connected to a minimum of 1.8 metres (6 feet) of 150mm (6”) flue pipe. 3. The horizontal flue run should not exceed 150mm (6”) 4.

  • Page 5: Important Operation/ Maintenance Notes

    IMPORTANT OPERATION / MAINTENANCE NOTES Now that your Stanley Solid Fuel Stove is installed and no doubt you are looking forward to many comforts it will provide, we would like to give you some tips on how to get the best results from your stove.

  • Page 6: Installation & Operating Instructions

    PRE INSTALLATION ASSEMBLY Please note that it is a legal requirement under Your Erin stove is supplied with the following items: England & Wales Building Regulations that the • Legs installation of the stove is either carried out under •...
  • Page 7 Fig.5 (B). Open the fire door using the detachable han dle and remove the contents from the fire box. Fig.3 (G). Remove the four M10 bolts from the base, (C). Remove the hob and place to one side, tak and fit the four legs using the four M10 x ing care not to damage the enamel finish.

  • Page 8: Flues

    Fig.8 FLUES 2300 Flues should be vertical wherever possible and where a bend is necessary, it should not make an angle of more than 45 with the vertical. Horizontal flue runs should be avoided except in the case of a back outlet from the appliance, when the length of the horizontal section should not exceed 150mm.

  • Page 9: Down Draughts

    TOP FLUE EXIT DOWN DRAUGHTS However well designed constructed and positioned, Take the flue spigot and before fitting it to the stove the satisfactory performance of the flue can be place a small amount of fire cement on the inside adversely affected by down draught caused by near- flange of the outlet and push the flue spigot into by hills, adjacent tall buildings or trees.

  • Page 10: Ventilation & Combustion Air Requirements

    The effective free area of any vent should be ascer- There are several conditions to be considered in tained before installation. The effect of any grills selecting a location for your Stanley Erin Stove. should be allowed for when determining the effective free area of any vent.

  • Page 11: Floor Protection

    Fig.15 FLOOR PROTECTION When installing this heater on a combustible floor, a floor protector, consisting of a layer of non com- bustible material at least ” (10mm) thick or ” (6mm) thick covered with ” (3mm) sheet metal. It is required to cover the area under the heater and to extend to at least 18”...

  • Page 12: Air Controls

    Fig.18 Air Wash Control Fig.16 Fig.19 AIR CONTROLS The stove has three independent air controls: The primary air control knob on the ashdoor (See fig. 16 &17). Move the knob to the right to open and to the left to close. The air wash control which is located above the firedoor (See fig.

  • Page 13: Technical Data

    Heat Model Class to Room to Water Index Fuel Output Net Efficiency Erin NB SF Stove 10.2 98.45 Wood 10.2 74.1 LIGHTING Before lighting the stove check with the installer that the installation work and commissioning checks described previously have been carried out correctly and that the chimney has been swept clean, is sound and free from any obstructions.

  • Page 14: Slow Burning

    AIR CONTROLS IGNITION CONTROLLED BURN FUEL PRIMARY AIRWASH SECONDARY PRIMARY AIR WASH SECONDARY FULLY FULLY FULLY 0-80% FULLY FULLY ANTHRACITE OPEN CLOSED CLOSED OPEN CLOSED CLOSED FULLY FULLY FULLY 0-80% 0-50% 0-50% COAL OPEN OPEN OPEN OPEN OPEN OPEN FULLY FULLY FULLY 0-10%...

  • Page 15: Monthly Maintenance

    MONTHLY MAINTENANCE PERIODIC MAINTENANCE ADJUSTING THE DOOR CATCH Cleaning Stove Flue Pathways Over time, the fire door latch can loosen due to the It is recommended that the flue pathways in the continual compression and hardening of the rope stove are cleaned on a monthly basis (or less seal between the door and the front casting.

  • Page 16: Chimney Cleaning

    CHIMNEY CLEANING CLEANING A MATT BLACK/SENOTHERM STOVE The chimney should be cleaned twice annually or if the stove is not used for a prolonged period during Cleaning should be done when the stove is cold by the summer period, it should be cleaned prior to removing any dust or dirt using a dry cloth.

  • Page 17: Fire Safety

    FIRE SAFETY TO REPLACE DAMAGED BRICKS Clean the firebox thoroughly and remove any fire To provide reasonable fire safety, the following cement in the joints of the bricks. Remove the left should be given serious consideration. and right hand front bricks. Remove the two back bricks.

  • Page 18: Exploded View

    ERIN SOLID FUEL STOVE EXPLODED VIEW TOP FLUE OUTLET - B00053AXX FRONT ROCKER BAR - Q00044AXX LEG (SHORT) - B00054AXX BACK ROCKER BAR - Q00045AXX TOP FLUE BLANKING PLATE - B00055AXX ROCKER BAR FRAME - Q00047BXX ASHTRAY - B00056AXX FIRE FENCE RETAINER...
  • Page 19 NOTES...
  • Page 20 Manufactured by Waterford Stanley Ltd., Unit 401-403, IDA Industrial Estate, Cork Road, Waterford, Ireland. Tel: (051) 302300 Fax (051) 302315 YS 150517Rev 018 Item No: N00229AXX...

Table of Contents