Installation Of Optional Accessories - Stanley IK900 Instruction Manual

• Standard installation of the insert:
Figure 12 – Electrical connection

7. Installation of optional accessories

Installing the display outside the equipment
It is possible to install the display outside the insert. It's an option that allows the installation of the display where it is most
2
practical, up to a maximum length of 30m using a parallel cable with a 0.75 mm section. In this way, the operation of the insert
can be controlled without being close to the heat source, even from another division. This installation requires two additional
components: the blind cover for the insert and the frame to attach the display to the wall. Sufficient cable length must be left so
that the moving part of the equipment can be removed without causing strain on the cable and does not interfere with the
movement of the equipment guides. Steps for assembly:
Once you have chosen the location where the display will be installed, you should make a hole in the wall with the help of the plate
that will support the display on the back. Place it next on the wall, making sure it is levelled and with the help of a pencil mark the
hole as shown in the figure.
Figure 13 – Installing the display outside the insert
1. Place the outer support plate, making it coincide with the markings done previously as shown in the figure with the hole, mark
the 4 holes where the screws pass.
Figure 14 – Installing the display outside the device
10