Additional Devices; Out Of The Box - DSC Power632 PC1565 Installation Manual

1.2

Additional Devices

In addition to the information below, see the back cover for a
DSC module compatibility table.
PC5132 Wireless Receiver
The PC5132 Wireless Receiver can be used to connect up to
8 wireless devices to the system. All devices are narrow band,
fully supervised devices which use standard 'AAA' or 'AA'
alkaline batteries.
Four devices will be available. They are as follows:
WLS904 Wireless Motion Detector
WLS906 Wireless Smoke Detector
WLS907 Wireless Slimline Universal Transmitter
WLS909 Wireless Key
Adds a simple and mobile method of arming and disarming to
the system, as well as one-button access to several program-
mable functions.
PC5400 Printer Module
The PC5400 Printer Module allows the panel to print out all
events that occur on the system to any serial printer. The print-
out will contain the time, date and the event that occurred.
GSM1000 Cellular Communicator
The GSM1000 Cellular Communicator can be used three dif-
ferent ways: as the sole communicator for the panel, as a
backup for either or both telephone numbers or as a redun-
dant backup to the land line communicator where the panel
will call both the land line and via the GSM1000.
LINKS2X50
Either the LINKS2150 or LINKS2450 may be used to transmit
alarm information over a long range radio network.
Cabinets
Several different cabinets are available for the PC1565 mod-
ules. They are as follows:
Special UK Cabinet
Main control cabinet for the PC1565 main panel. Dimensions
288mm x 298mm x 78mm / 11.3" x 11.7" x 3" approximately.
PC500C Cabinet with Removable Door
Main control cabinet for the PC1565 main panel. Dimensions
213mm x 235mm x 78mm / 8.4" x 9.25" x 3" approximately.
PC5004C Cabinet
Cabinet to house the PC5400 Printer Module. Dimensions
229mm x 178mm x 65mm / 9" x 7" x 2.6" approximately.
2
1.3

Out of the Box

Please verify that the following components are included in
your system:
• one main control cabinet
• one PC1565 main control circuit board
• one keypad with zone input
• one Installation Manual with programming worksheets
• one Instruction Manual for the end user
• one hardware pack consisting of:
- one mylar cabinet label
- four plastic circuit board standoffs
- sixteen 5600Ω (5.6K) resistors
- one 2200Ω (2.2K) resistor
- one 1000Ω (1K) resistor
- ground connection assembly
- one cabinet door plug (if required)