Additional Devices; Out Of The Box - DSC Power632 Installation Manual

1.2

Additional Devices

In addition to the information below, see the back cover for a
DSC module compatibility table.
PC5132 Wireless Receiver
The PC5132 Wireless Receiver can be used to connect up to
32 wireless devices to the system. All devices are spread
spectrum, 900 MHz, fully supervised devices which use stan-
dard 'AAA' or 'AA' alkaline batteries.
Seven devices are available. They are as follows:
WLS904 Wireless Motion Detector:
tection to your system
WLS905 Wireless Universal Transmitter:
or window contacts to your system.
WLS906 Wireless Smoke Detector:
your system.
WLS907 Wireless Slimline Universal Transmitter:
wireless door or window contact.
WLS908 Wireless Panic Pendant:
the system. When used, the unit will indicate a non-medical emer-
gency to the central station.
WLS909 Wireless Key:
Adds a simple and mobile method of arm-
ing and disarming to the system, as well as one-button access to sev-
eral programmable functions.
WLS910 Wireless Handheld Keypad:
allows arming and disarming from anywhere on the premises.
PC5400 Printer Module
The PC5400 Printer Module allows the panel to print out all
events that occur on the system to any serial printer. The print-
out will contain the time, date and the event that occurred.
GSM1000 Cellular Communicator
The GSM1000 Cellular Communicator can be used three dif-
ferent ways: as the sole communicator for the panel, as a
backup for either or both telephone numbers or as a redun-
dant backup to the land line communicator where the panel
will call both the land line and via the GSM.
LINKS2X50
Either the LINKS2150 or LINKS2450 may be used to transmit
alarm information over a long range radio network.
2
Adds wireless space pro-
Adds wireless door
Adds smoke detection to
A smaller
Adds personal protection to
A portable keypad which
PC5208 Low Current Output Module
The PC5208 adds eight low current outputs (50mA) to the
control panel. Each output is individually programmable with
PGM output options. Please refer to section 5.12 'PGM Output
Options' on page 21. See the PC5208 Installation Instructions
for more information.
Cabinets
Several different cabinets are available for the PC1565 mod-
ules. They are as follows:
PC5003C Cabinet
Main control cabinet for the PC1565 main panel. Dimensions
288mm x 298mm x 78mm / 11.3" x 11.7" x 3" approximately.
PC500C Cabinet
Main control cabinet for the PC1565 main panel. Dimensions
213mm x 235mm x 78mm / 8.4" x 9.25" x 3" approximately.
PC5004C Cabinet
Cabinet to house the PC5400 Printer Module. Dimensions
229mm x 178mm x 65mm / 9" x 7" x 2.6" approximately.
1.3

Out of the Box

Please verify that the following components are included in
your system:
• one main control cabinet
• one PC1565 main control circuit board
• one PC1555RKZ keypad with zone input
• one Installation Manual with programming worksheets
• one Instruction Manual for the end user
• one hardware pack consisting of:
- one mylar cabinet label
- four plastic circuit board standoffs
- thirteen 5600Ω (5.6K) resistors
- one 2200Ω (2.2K) resistor
- one 1000Ω (1K) resistor
- ground connection assembly
- one cabinet door plug (if required)
- six 8200Ω (8.2K) resistors