Table of Contents
Advertisement
S
Y
S
T
1.2
Additional Devices
In addition to the information below, see the back cover for a
DSC module compatibility table.
PC5132 Wireless Receiver
The PC5132 Wireless Receiver can be used to connect up to 8
wireless devices to the system. All devices are spread spectrum,
900 MHz, fully supervised devices which use standard 'AAA' or
'AA' alkaline batteries .
Seven additional devices are available. They are as follows:
WLS904 Wireless Motion Detector
WLS905 Wireless Universal Transmitter
Adds wireless door or window contacts to your system.
WLS906 Wireless Smoke Detector
WLS907 Wireless Slimline Universal Transmitter
A smaller wireless door or window contact.
WLS908 Wireless Panic Pendant
Adds personal protection to the system. When used, the unit will
indicate a non-medical emergency to the central station.
WLS909 Wireless Key
Adds a simple and mobile method of arming and disarming to
the system, as well as one-button access to several
programmable functions.
WLS910 Wireless Handheld Keypad
PC5400 Printer Module
The PC5400 Printer Module will allow the panel to print out all
events that occur on the system to any serial printer. The
printout will contain the time, date and the event that occurred.
PC5204 Power Supply Output Module
The PC5204 can provide up to 1 Amp of additional power for
modules or devices connected to the control panel. The module
requires a 16.5 volt AC 40 VA transformer and 4 AH battery. In
addition, the module provides 4 programmable high current
voltage outputs. Each output is individually programmable with
19 different output options available (See Section 5.11 "PGM
Outputs"). (See PC5204 Installation Instructions Sheet.)
PC5208 Eight Low Current Output Module
Adds eight low current outputs (50 mA) to the control. Each
output is individually programmable with 19 different output
options available (See Section 5.11 "PGM Outputs"). (See
PC5208 Installation Instructions Sheet.)
Escort5580 Module
This Escort5580 module will turn any touch tone phone into a
fully functional keypad. The module also includes a built-in
interface to control up to 32 line carrier type devices for lighting
and temperature control . (See Escort5580 Installation Manual.)
PC5928 Audio Interface Module
The PC5928 Audio Interface module is a simple way to incorporate
paging, intercom, baby listen-in and door answer to the PC5008
control panel. The module also has built-in talk/listen voice
capability for central station . Four additional devices are available:
PC5921 Intercom Audio Station
Used in conjunction with the PC5928 Audio Interface Module .
PC5921 EXT Door Box Audio Station
Used in conjunction with the PC5928 Audio Interface Module .
PC5921 EXT/R Door Box Audio Station
Used in conjunction with the PC5928 Audio Interface Module. The
Door Box contains a relay so the normal door bell can be used
instead of the internal one generated by the PC5928 module.
E
M
V
I
N
T
R
O
PC5904 Central Station Talk/Listen Module
Used in conjunction with the PC5928 audio interface module for
Talk/Listen-In purposes. This station provides an added level of
volume to the central station operator's voice.
Each station has a separate microphone and speaker. Each
station must be home run to the interface module using shielded
22 gauge, 4 conductor wire. All stations can be used to sound an
alarm follower.
LINKS 1000 Cellular Communicator
The LINKS 1000 Cellular Communicator can be used three
different ways: as the sole communicator for the panel, as a
backup for either or both telephone numbers or as a redundant
backup to the land line communicator where the panel will call
both the land line and via the LINKS.
LINKS2X50
Either the LINKS2150 or LINKS2450 may be used to transmit
alarm information over a long range radio network.
Cabinets
Several different cabinets are available for the PC5008 modules.
They are as follows:
PC5003C Cabinet
Main control cabinet for the PC5008 main panel. Dimensions
288mm x 298mm x 78mm / 11.3" x 11.7" x 3" approximately.
PC500 Cabinet with Removable Door
Main control cabinet for the PC5008 main panel. Dimensions
213mm x 235mm x 78mm / 8.4" x 9.25" x 3" approximately.
PC5004C Cabinet
Cabinet to house the PC5400 Printer Module. Dimensions
229mm x 178mm x 65mm / 9" x 7" x 2.6" approximately.
Backplates
There are two different backplates available for keypads to
locate an Audio Station next to the keypad:
PC55BP1 Backplate
This backplate is to be used when an Audio Station is to be
located next to a keypad. Dimensions 208mm x 115mm x 18mm
/ 8.2" x 4.5" x 0.25" approximately.
PC55BP2 Backplate
This backplate is to be used when an Audio Station is to be
located next to a keypad. In addition the backplate will allow
you to mount a PC5108 Zone Expander Module or the PC5208
Eight Low Current Output Module. Dimensions 208mm x 115mm
x 18mm / 8.2" x 4.5" x 0.7" approximately.
1.3
Out of the Box
Please verify that the following components are included in
your system:
• one PC5003C main control cabinet
• one PC5008 main control circuit board
• one Power keypad with zone input
• one Installation Manual with programming worksheets
• one Instruction Manual for the end user
• one hardware pack consisting of:
- one mylar cabinet label
- four plastic circuit board standoffs
- fourteen 5600Ω (5.6K) resistors
- one 2200Ω (2.2K) resistor
- one 1000Ω (1K) resistor
- ground connection assembly
- one cabinet door plug
2
D
U
C
T
I
O
N
Advertisement
Table of Contents
