Additional Devices; Out Of The Box - DSC power608 Installation Manual

1.2

Additional Devices

In addition to the information below, see the back cover for a
DSC module compatibility table.
PC5132 Wireless Receiver
The PC5132 Wireless Receiver can be used to connect up to
8 wireless devices to the system. All devices are narrow band,
418MHz, fully supervised devices which use standard 'AAA'
or 'AA' alkaline batteries.
Four devices will be available. They are as follows:
WLS904 Wireless Motion Detector
WLS906 Wireless Smoke Detector
WLS907 Wireless Slimline Universal Transmitter
WLS909 Wireless Key
Adds a simple and mobile method of arming and disarming to
the system, as well as one-button access to several program-
mable functions.
PC5400 Printer Module
The PC5400 Printer Module allows the panel to print out all
events that occur on the system to any serial printer. The print-
out will contain the time, date and the event that occurred.
PC5204 Power Supply Output Module
The PC5204 can provide up to 1 Amp of additional power for
modules or devices connected to the control panel. The mod-
ule requires a 16.5 volt AC 40 VA transformer and 4 AH bat-
tery. In addition, the module provides 4 programmable high
current voltage outputs. Each output is individually program-
mable with 20 different output options available. (See 5.11
"PGM Output Options" on page 20.) (See PC5204 Installation
Instructions Sheet.)
PC5208 Eight Low Current Output Module
Adds eight low current outputs (50 mA) to the control. Each
output is individually programmable with 20 different output
options available. (See 5.11 "PGM Output Options" on page
20.) (See PC5208 Installation Instructions Sheet.)
Escort5580 Module
This Escort5580 module will turn any touch tone phone into a
fully functional keypad. The module also includes a built-in
interface to control up to 32 line carrier type devices for light-
ing and temperature control. (See Escort5580 Installation
Manual.)
PC5928 Audio Interface Module
The PC5928 Audio Interface module is a simple way to incor-
porate paging, intercom, baby listen-in and door answer to
the PC5008 control panel. The module also has built-in talk/lis-
ten voice capability for central station. Four additional devices
are available:
PC5921 Intercom Audio Station
Used in conjunction with the PC5928 Audio Interface Module.
PC5921 EXT Door Box Audio Station
Used in conjunction with the PC5928 Audio Interface Module.
PC5921 EXT/R Door Box Audio Station
Used in conjunction with the PC5928 Audio Interface Module.
The Door Box contains a relay so the normal door bell can be
used instead of the internal one generated by the PC5928
module.
PC5904 Central Station Talk/Listen Module
Used in conjunction with the PC5928 audio interface module
for Talk/Listen-In purposes. This station provides an added
level of volume to the central station operator's voice.
Each station has a separate microphone and speaker. Each
station must be home run to the interface module using
2
shielded 22 gauge, 4 conductor wire. All stations can be used
to sound an alarm follower.
LINKS2X50
Either the LINKS2150 or LINKS2450 may be used to transmit
alarm information over a long range radio network.
Cabinets
Several different cabinets are available for the PC5008 mod-
ules. They are as follows:
Special UK Cabinet
Main control cabinet for the PC5008 main panel. Dimensions
288mm x 298mm x 78mm / 11.3" x 11.7" x 3" approximately.
PC500 Cabinet with Removable Door
Main control cabinet for the PC5008 main panel. Dimensions
213mm x 235mm x 78mm / 8.4" x 9.25" x 3" approximately.
PC5004C Cabinet
Cabinet to house the PC5400 Printer Module. Dimensions
229mm x 178mm x 65mm / 9" x 7" x 2.6" approximately.
Backplates
There are two different backplates available for keypads to
locate an Audio Station next to the keypad:
PC55BP1 Backplate
This backplate is to be used when an Audio Station is to be
located next to a keypad. Dimensions 208mm x 115mm x
18mm / 8.2" x 4.5" x 0.25" approximately.
PC55BP2 Backplate
This backplate is to be used when an Audio Station is to be
located next to a keypad. In addition the backplate will allow
you to mount a PC5208 Eight Low Current Output Module.
Dimensions 208mm x 115mm x 18mm / 8.2" x 4.5" x 0.7"
approximately.
1.3

Out of the Box

Please verify that the following components are included in
your system:
• one Special UK cabinet
• one PC5008 main control circuit board
• one Power keypad with zone input
• one Installation Manual with programming worksheets
• one Instruction Manual for the end user
• one hardware pack consisting of:
- one mylar cabinet label
- four plastic circuit board standoffs
- sixteen 5600Ω (5.6K) resistors
- one 2200Ω (2.2K) resistor
- one 1000Ω (1K) resistor
- ground connection assembly
- one cabinet door plug