Volt-Ampere Curves; Section 3 - Installation; Selecting A Location - Hobart Handler 130 XL Owner's Manual

2-3. Volt-Ampere Curves

3-1. Selecting A Location

OM-210 082 Page 10
SECTION 3 – INSTALLATION
18 in
(460 mm)
The volt-ampere curves show the
minimum and maximum voltage
and amperage output capabilities of
the welding power source. Curves
of other settings fall between the
curves shown.
1 Rating Label
18 in
2 Grounded Receptacle
(460 mm)
A 115 volt, 20 ampere individual
2
branch circuit protected by time-de-
lay fuses or circuit breaker is re-
quired.
1
3 Plug From Unit
Select extension cord of 12 AWG
3
for up to 75 ft (23 m) or 10 AWG for
up to 140 ft (46 m).
Y Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
ssb1.1 10/91 – SB-185 560
ST-802 025