Table of Contents
Advertisement
24
Finalizing the Installation
Diffuser Plate Adjustment
Certain vent configurations require the diffuser plate to be adjusted (refer to the approved vent
configuration charts for details). Position # 1 is stock (bent). Position # 2 is flattened. See the directions
below to change the diffuser to position #2.
© Travis Industries
DIFFUSER SIDE VIEW
Before (Stock - Position # 1)
After (Position # 2)
(for qualified installers only)
Bend the round portion of the
diffuser so it is flat (position # 2).
6/28/2019 - 1499
Remove the exhaust
restrictor.
1/4" Nutdriver
1/4" Nutdriver
Remove the diffuser.
Secure the flattened
diffuser plate with the
screws removed earlier.
Replace the exhaust
restrictor (see "Exhaust
Restrictor Adjustment"
for restrictor settings).
864 40K CF Install Aust
Advertisement
Table of Contents
