Table of Contents
Advertisement
Finalizing the Installation
Using a Buildout Below a Television
IMPORTANT NOTE REGARDING TELEVISIONS AND THIS FIREPLACE
Most television manufacturers instruct the homeowner to not place the television above a heat source. Doing so may
negatively affect the longevity of the television and may negate the warranty. If you do place a television above the
fireplace, please be aware of the large amount of heat generated by the fireplace and consider placing the television
above a mantel to reduce the amount of heat that reaches the television. The homeowner must understand that
Travis Industries does not take responsibility for any negative impact to televisions placed near this fireplace.
Min. 2" (51mm)
From Front of TV
b
Minimum Dimensions:
(a) Minimum Buildout Height above Base of Fireplace*
(b) Minimum Buildout Depth*
(c) Fireplace Buildout Width
* Buildout depth is 8" (203mm) minimum to allow heat to travel forward and dissipate. If using more than an
8" (203mm) buildout, make sure to make the buildout height (a) higher (buildout must meet mantel
requirements - see page 31 for details).
NOTE: The buildout must extend 2" (51mm) in front of the TV and 3" (77mm) to both sides and top. If you have a TV
that is greater than 6" (152mm) deep (including the 1" (26mm) gap behind), you will need to alter the buildout depth
and height.
WIRING NOTE: If running wiring into the enclosure, use thermal insulating wrap around the wiring. Secure the wiring
to protect from contact with hot surfaces.
© Travis Industries
(for qualified installers only)
Min. 1" (26mm) Air Gap Behind TV
(typically provided by wall mount)
Television (TV)
Min. 6"
Min. 6"
(152mm)
(152mm)
a
Fireplace
c
44-3/4" (1137mm) with 8" (203mm) buildout depth
Minimum 8" (203mm)*
43" (1093mm)
6/28/2019 - 1499
Min. 1" (26mm)
864 40K CF Install Aust
13
Advertisement
Table of Contents
