Table of Contents
Advertisement
Electrical connection
8.3 System integration
8.3.5.2
Motors without DRIVE-CLiQ interface
If a motor is not equipped with a DRIVE-CLiQ interface, the speed encoder and temperature
sensor are connected via a signal connector.
1
Figure 8-12
Motors without DRIVE-CLiQ require a Sensor Module Cabinet (SMC) for operation with a
SINAMICS S120 drive system. The motor is connected with the SMC using a MOTION-
CONNECT signal cable.
Figure 8-13
Information on the connector pin assignment is provided in Chapter "PIN assignment of the
signal connectors (Page 393)".
392
17-pin M23 signal connector
Motor with a signal connector
Encoder interface without DRIVE-CLiQ
S-1FT7 synchronous motors
Configuration Manual, 09/2018, A5E45099423B AA
Advertisement
Table of Contents
