Table of Contents
Advertisement
16 Installing and initializing the i2004 Etherset
2.2
Initializing the i2004 Etherset
When you first connect your Etherset to a power source, all hardkey indicator
lights and softkey icons may flash. This indicates that the phone has not yet
been initalized.
The following steps describe the initialization procedure for the i2004
Etherset.
1 Power the Etherset on by connecting it to the power source, or by
2 The Etherset will begin initializing. When the screen in Figure 4 is shown,
Figure 4 Initializing screen
Version 1.8
disconnecting and reconnecting the AC power adaptor plug.
press each of the Softkeys once from left to right. This will allow you to
configure the Etherset.
Note: This must be done as soon as the screen appears. If you do not
press the buttons quickly, the screen in Figure 5 will appear. If this occurs,
disconnect the Etherset from the power source and reattempt the
initialization procedure.
If the screen in Figure 4 does not appear, contact your system
administrator, as your Etherset will need to be upgraded.
Press these buttons
once from left to right
upon seeing this
screen.
August 2002
Advertisement
Table of Contents
