Table of Contents
Advertisement
R
F. Hearth Support For Standard Surround (Cont'd)
Base Plate Only Installation
Parts Needed: (1) cast ring (2) base zero clearance panel
extensions. Discard balance of parts.
Tools Needed: Phillips head screwdriver
1. Attach base zero clearance panel extensions to cast
ring.
2. Place assembly under appliance.
Cast Trim Footer
Panel Leg
Panel Extension
Figure 34.1
G. Surround & Trim Set, Econo
(CASTILE INSERT)
Included in Surround & Trim Kit: (2) corner brackets and
set screws; (1) trim set, 3 piece; (2) side surrounds; (1)
top surround; (4) screws;
Tools Needed: Powered Phillips head screw driver
1. Secure the top surround to the surround sides
with the screws provided. Figure 34.2.
2. Assemble the trim with the (2) corner brackets
provided. Figure 34.3.
3. Slide the assembled trim over the assembled
surround set.
4. Remove the cast sides before attaching the
surround and trim. Lift up the top to expose the
thumb screws at the top of cast side. Figure
34.4.
5. Remove the thumb screw and top bracket and
then remove the cast side. Lay it down on a soft
surface to avoid scratching the cast.
Slide surround and trim over the top of the insert
6.
into place. Surround attachs to insert at the top
and bottom of insert side. Figure 34.4.
7. Re-install the cast sides and secure with the
thumb screws.
October 27, 2011
Back of Top Panel
Figure 34.2
View of "L" Bracket
installed
Figure 34.3
Surround Set
attaches to top
and bottom of
insert sides.
Figure 34.4
7069-101B
Castile & Santa Fe CE Insert
Screws
Back of Side Panel
Thumb
Screw
Bracket
Page 31
Advertisement
Table of Contents
