Adjustable Hopper Options; Grill Installation; Adjustable Hearth Support - Quadra-Fire CB1200MI-MBK Installation Manual

CB1200 Pellet Insert
C. Adjustable Hopper Options
Depending on your installation, the hopper can be adjusted
down 2-1/2 inches (64mm) and will decrease in capacity
from 75lbs to 60lbs.
To adjust hopper:
1. Using a Phillips head screw drive, remove all the screws
from the top of the hopper securing the top hopper piece
to the bottom hopper piece and insert body.
2. Adjust downward 2-1/2 inches (64mm).
3. Mark location for new holes and drill new holes.
4. Secure hopper pieces together using screws removed in
step one.
5. See drawing on page 8, Figures 8.1 and 8.2.
D. Grill Installation
1. Remove grill from packaging.
2. Lift top up.
3. Align the 3 holes in the insert with the holes in the grill.
4. Use a Phillips screw driver to secure in place. It will be
necessary to go through the hole in the bag support shelf
to gain access to the screw. Figure 22.1.
5. Lower the top into position.
Bag Support Shelf
Figure 22.1
22
E. Adjustable Hearth Support
Size: 9"D x 45"W, 2" to 10" Height Adjustment
Included in Kit: (1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed: Phillips head screw driver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 23.1 on page 23.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screw driver. Figure
23.2 on page 23.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trims edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 23.3 on page 23.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims to
scissors has a powerful bonding adhesive. Adjustments
are extremely difficult once trim has adhered to tape. Do
a dry run first without removing paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on first and then front piece.
The front piece overlaps side pieces.
7. Once you are satisfied with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. There are 3 holes in the back flange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material, i.e., brick, sheet rock, etc.
NOTE: 3/8 inch (9.5mm) thick tile or like material can be
cut to size and fit under lip of top trim edge for a decora-
tive touch. Figure 23.3 on page 23.
Sheet metal trim edges will be sharp.
For safety purposes wear gloves.
Injury can occur.
7014-285A
WARNING
October 9, 2017