Table of Contents
Advertisement
R
C. Door Handle Removal
1. Open the outer door.
2. Unlatch and open the firebox door.
3. Continue to turn handle until it is free from the firebox
door.
D. Door Removal
1. Open the outer door.
2. Unlatch and open the firebox door.
3. Lift the firebox door up, freeing it from the firebox hinges.
E. Adjustable Hearth Support
Size: 229mm d x 1143mm w, 51mm to 254mm
Height Adjustment
Included in Kit: (1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed: Phillips head screwdriver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 32.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screwdriver.
3. Measure front and side trims to required height
to cover scissors and mark pieces for cutting. Cut
excess material from top of trim's edge, not bottom.
This edge will be sharp; wear gloves to prevent injury
to your hands. Figure 32.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it
allows for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a powerful bonding adhesive. Adjust-
ments are extremely difficult once trim has adhered to
tape. Do a dry run first without removing paper from
tape.
6. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on first and then front
piece. The front piece overlaps side pieces.
7. Once you are satisfied with the positioning, remove
trim and set aside.
8. Remove the paper from double-sided tape that is
to accept trim side. Align side and then press hard
against tape to secure side piece. Repeat for other
side. Install front trim piece last.
October 27, 2011
9. There are 3 holes in the back flange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material, i.e., brick, sheetrock, etc.
NOTE: 9.5mm thick tile or like material can be cut to size
and fit under lip of top trim edge for a decorative touch.
Figure 32.3.
DOUBLE-SIDED TAPE
Figure 32.1
EXPAND SCISSORS TO DESIRED HEIGHT
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
Figure 32.2
Figure 32.3
Sheet metal trim edges will be sharp.
For safety purposes wear gloves.
Injury can occur.
7069-101B
Castile & Santa Fe CE Insert
EXPLODED VIEW OF SCISSORS
SCREWS ARE CIRCLED
DOUBLE-SIDED TAPE
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
TRIM PIECES
WARNING
Decorative tile
may be installed
Page 29
Advertisement
Table of Contents
