Hearth Support; Removal Of Cast Sides - Quadra-Fire MTVERNINSAE-MBK Installation Manual

C. Hearth Support
Included in Kit: (1) bottom, (1) trim front, (2) trim sides, (2)
trim extensions
Tools Needed: Phillips head screw driver, measuring tape,
gloves
1. Remove contents from box and lay on protective surface
to avoid scratching the paint.
2. Lay front and sides face down. Bend the tabs down toward
the inside. Figure 19.1.
3. The side pieces are shipped flat. It is must easier to flex the
sides into a bowed position before installing.
4. Lay the cast bottom face up. Attach the 2 sides FIRST and
then the front piece. Figure 19.2.
5. Turn the cast bottom right side up and attach the panel
extensions. Note the alignment hole.
6. Attach the appropriate footers depending on the panels &
trim set you are installing. The footers come in 2 sizes, 3
and 5 inches. Discard the footers not used.
Bend tabs down. Shipped
flat from the factory.
Figure 19.1
3 inch
high Set
5 inch
high Set
Install Front Trim Last,
Corner Overlap Side
Trim Pieces
Figure 19.2
October 3, 2017
Attach Trim to Insert from
inside Insert.
Basic
Cast
5 in
Attach Trim to Base
from underneath
7. Place the assembled hearth support under the insert.
Lower the leveling bolts if necessary to keep the insert
level.
8. Open the door and attach the hearth support to the insert.
There are 9 attachment holes. Figure 19.3.
Figure 19.3
D. Removal of Cast Sides
You will need to remove the cast sides in order to install
the panel and trim set.
1. There is a latch on the back side of the cast side in the
middle of the top opening of the cast side as indicated
in Figure 19.4.
2. Place your fingers inside the opening and squeeze
the latch. The side can now be pulled toward you and
removed. Place on a protective surface so as not to
damage the finish.
3. To replace the side, set the bottom in first. Squeeze
the latch in an open position. Place the cast side into
position and then release the latch. The latch hooks
onto a bracket to hold the side in place.
3 in
Figure 19.4 - Shown with Cast Panel Set
7036-188J
MT VERNON AE INSERT
9 attachment holes - 3 on
each side and 3 in the front
Location of Latch
for Removing
Cast Sides
Lower the leveling
bolts if necessary to
keep the insert level
when installing the

Hearth Support.

19