Table of Contents
Advertisement
Castile & Santa Fe CE Insert
H. Surround and Cast Trim Set
(CASTILE INSERT)
I
ncluded in Surround Kit: (2) side surrounds, left and
right; (1) surround top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right; (1)
cast trim header; (2) cast trim footers, left and right
Tools Needed: Powered 102mm to 152mm Phillips head
screwdriver
1.
Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2. Lay the surround set face down on protective covering to
prevent scratching the painted surface.
3. Using a 102mm to 152mm long Phillips head screwdriver to
attach the side surrounds to the top surround using (2) #8
sheet metal screws on each side provided with the kit.
4. Place the peel and stick round felt vibration insulation pads on
the front side in each corner of the top metal piece and on the
back side in each corner of the top cast piece. Figure 32.1.
5. Place the corresponding cast trim pieces (2 cast trim sides
and 1 cast trim header) underneath the surround set, also face
down. Align the holes in the metal pieces with the 5 bosses
on the top cast piece and 2 bosses on each side piece.
6. Secure the magnet to the bracket and attach the magnet and
bracket to each metal side piece at the bottom. The magnet
is facing the front. Figure 32.2.
7. Place the cast footers under the metal sides aligning the top
and bottom holes in the cast footers and metal sides.
8. The 9 mounting clips are shipped in one long strip. Hand
break apart or use pliers.
9. Each clip has a clearance notch to allow room for the cast
on the insert. Place the clip so the notch is facing the outer
edges of the surrounds. Figure 32.3.
10. It is best to install all of the 1/4-20 screws only half way at
first to allow for adjustments. After adjustment, tighten the 2
screws in each cast footer first and then work your way around
to the rest.
11 Remove the cast sides before attaching the surround
and trim. Lift up the top to expose the thumb screws at
the top of cast side. Figure 32.4.
12. Remove the thumb screw and top bracket and then
remove the cast side. Lay it down on a soft surface to
avoid scratching the cast.
Slide surround and trim over the top of the insert into
13
place. Surround attachs to insert at the top and bottom
of insert side. Figure 32.4.
14. Re-install the cast sides and secure with the thumb
screws.
CAUTION
Do not pick up assembled appliance by corners.
It is too heavy and may damage the surrounds.
Pick up from center.
Page 32
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Figure 32.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Figure 32.2
Surround Set
attaches to top
and bottom of
insert sides.
Figure 32.4
7069-101B
Cast Footers,
Left & Right
Clearance Notch
Figure 32.3
Thumb
Screw
October 27, 2011
R
Bracket
Advertisement
Table of Contents
