Table of Contents
Advertisement
R
I. Panel and Trim Set
(SANTA FE INSERT)
1. Lay panel top and legs face down on protective cov-
ering to prevent scratching.
1. Attach the panel legs to the top panel using a Phillips
head screwdriver. There are 2 screws for each leg.
Figure 36.2.
2. Open the hopper lid by pulling toward you. This will
make it easier to set the panels in place. Secure the
panels to the insert, 2 screws per leg, as shown in
Figure 36.3.
3. Connect the trim pieces together using the "L" Brack-
ets supplied. Figure 36.4.
4. Slide the trim over the top of the panels.
5. Install the access panels. At the bottom of the access
panel there are 2 hooks that slip into a slot at the
bottom of the side panel and a magnet at the top that
holds the access panel in place. Figure 36.3.
Figure 36.1- Completed View
October 27, 2011
Attach panel
legs to top
Figure 36.2
Open Hopper Lid for
Easier Placement of
Panel Set
Access Panels
Figure 36.3
View of "L" Bracket
installed
Figure 36.4
7069-101B
Castile & Santa Fe CE Insert
Magnet
Hook
Page 33
Advertisement
Table of Contents
