Adjustable Hearth Support - Quadra-Fire CB1200MI-MBK Owner's Manual Installation And Operation

R
E. Adjustable Hearth Support
Size: 9"D x 45"W, 2" to 10" Height Adjustment
Included in Kit: (1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed: Phillips head screw driver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 21.1.
2. Expand scissors to desired height. Tighten screws to hold
in place using Phillips head screw driver. Figure 21.2.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trim's edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 21.3.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fi ts under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims to
scissors has a powerful bonding adhesive. Adjustments
are extremely diffi cult once trim has adhered to tape. Do
a dry run fi rst without removing paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on fi rst and then front piece.
The front piece overlaps side pieces.
7. Once you are satisfi ed with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. There are 3 holes in the back fl ange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material, i.e., brick, sheetrock, etc.
NOTE: 3/8 inch (9.5mm) thick tile or like material can be
cut to size and fi t under lip of top trim edge for a decora-
tive touch. Figure 21.3.
Sheet metal trim edges will be sharp.
For safety purposes wear gloves.
Injury can occur.
November 22, 2011
WARNING
Figure 21.1
Figure 21.2
Figure 21.3
7014-188C
CB1200-I Pellet Insert
Page 21