Graco Gusmer Reactor H-25 Operation page 23

2. Set temperatures
A
B
Temperature Controls and Indicators, see page 12
This equipment is used with heated fluid, which can
cause equipment surfaces to become very hot. To
avoid severe burns:
• Do not touch hot fluid or equipment.
• Allow equipment to cool completely before touch-
ing it.
• Wear gloves if fluid temperature exceeds 110°F
(43°C).
a.
Turn main power ON
b.
Press
perature scale.
c.
Press
311299C
° F
° C
.
° F °
C
or to change tem-
.
A
d.
To set
ture, press
shows desired temperature. Repeat for
B
and
For zone only, if FTS is disconnected at star-
tup, display will show hose current (0A). See step h,
page 24.
e.
Press
tures.
Do not turn on hose heat without fluid in hoses.
f.
Turn on
. Preheat hose (15-60 min). Indi-
cator will flash very slowly when fluid
reaches target temperature. Display
shows actual fluid temperature in hose
near FTS.
Startup
heat zone target tempera-
or until display
zones.
to display actual tempera-
heat zone by pressing
23