Roland S-1 Owner's Manual page 69

Item Value
vELo 1–127
(Key Velocity)
tUnE 433. 0 –448. 0
(Tune)
OFF, 1–127
USb. d
(USB Direct Out)
OFF, On
A. L nK
(AIRA Link) (*2)
Cnt. I OFF, 2–4
(Count In)
OFF, rEC (Rec),
Ntro rC. P L (Rec&Play)
(Metronome)
Ntr. L 0–100
(Metronome
Level)
OFF, On
d. L at
(D-Motion Latch)
Copies the current pattern to a specified pattern. The copy destination number is shown in the display.
Use the [TEMPO/VALUE] knob to select the copy destination number.
COPy
●
(Pattern Copy) Press pad [2] (ENTER) to copy.
●
If you want to cancel, press pad [1] (EXIT).
Initializes the currently selected pattern (performance data and tones).
init
(Pattern Initialize)
Reloads the pattern.
rLod
(Reload All) rLod (Reload All): The selected pattern is restored to its last saved state.
rL. S d rL. S d (Reload Sound): The tone of the selected pattern is restored to its last saved state.
(Reload Sound)
* You can also hold down the [SHIFT] button and press the [1] + [POLY] pads to do this.
rL. S q
(Reload
rL. S q (Reload Sequence): The performance data of the selected pattern is restored to its last saved state.
Sequence)
*1: The settings are made for the currently selected pattern (and can be saved for each pattern).
*2: When using with another port besides the USB HOST 3 port on the MX-1, the unit starts up in battery-only mode. To use
battery-only mode, turn on the power while holding down pad [1] (EXIT).
Explanation
Sets the keyboard velocity.
Sets the master tuning.
Default value: 440.0 Hz
Configures the volume of the signal output to USB.
OFF: Uses the VOLUME knob's setting.
1–127: Sets the volume apart from the VOLUME knob's setting.
Set this to "On" when connecting a device via USB that is compatible with AIRA LINK,
such as the MX-1.
Otherwise, leave this at the "OFF" setting. The setting takes effect after the unit is
powered off and on again.
Sets the length (the number of beats) of the count-in for recording.
Sets whether and when the metronome plays.
OFF: Always off
rEC (Rec): Turns on only when recording
rC. P L (Rec&Play): Turns on during recording and playback
Sets the metronome level.
Sets whether to use latch operations for the [D-MOTION] button or not.
Default value: OFF
OFF: D-MOTION turns "ON" while you press the button (momentary operation).
On: D-MOTION toggles between ON/OFF each time you press the button (latch
operation).
Using the menus
69