Roland S-1 Owner's Manual page 5

Table of Contents

Advertisement

5–35°C
However, in order to take full advantage of the lithium-ion battery's performance, we recommend that you charge it in a
temperature range of 10–30°C.
* Use cables with monaural mini phone type plugs to connect to/from the SYNC IN/OUT jacks. Do not use cables with stereo
mini phone type plugs, as these cables do not work.
* Do not connect an audio device to the SYNC OUT jack. Doing so may cause a malfunction.
* If an external device is connected to the SYNC IN jack, the unit synchronizes with the clocks inputted to the SYNC IN jack,
regardless of the MIDI Clock Sync setting.
* Use cables with stereo mini phone type plugs to connect to/from the MIX IN/OUT jacks. Do not use cables with monaural
mini phone type plugs, as these cables do not work.
2.
Controller
Explanation
This is a four-digit, seven-segment LED display.
Display
If a pattern has been edited, a dot lights up on the right side of the display.
Changes the values shown in the display.
[TEMPO/VALUE]
Use this knob with the [SHIFT] button to fine-tune the tempo or to make larger adjustments to the
knob
parameter values.
Plays the pattern.
[ø] (PLAY) button
Press the button again to stop playback.
Switches the unit to recording standby.
Recording starts when pattern playback begins.
[ó] (REC) button
When you press a keyboard pad or turn a knob, the corresponding note or parameter change is recorded
to the step sequencer.
3.
Section
Controller
[RATE] knob
LFO
[WAVE FORM] knob
[RANGE] knob
[LFO] knob
[
] (Square wave)
knob
OSCILLATOR
[
] (Sawtooth wave)
knob
[SUB] knob
[NOISE] knob
[FREQ] knob
[RESO] knob
FILTER
[LFO] knob
[ENV] knob
[ATTACK] knob
[DECAY] knob
ENV
[SUSTAIN] knob
[RELEASE] knob
[DELAY] knob
EFX
[REVERB] knob
Explanation
Determines the LFO's modulation speed.
Selects the LFO waveform.
(sawtooth wave),
(inverted sawtooth wave),
(triangle wave),
(square wave),
RND (random),
NOISE (noise)
Sets the octave of the oscillator.
Adjusts the intensity at which LFO modulates the oscillator.
Adjusts the level of the square wave.
Adjusts the level of the sawtooth wave.
Adjusts the level of the sub oscillator.
Adjusts the level of the noise.
Sets the cutoff frequency of the low-pass filter.
Emphasizes the frequencies around the filter's cutoff frequency.
When the cutoff frequency is set to be controlled by the LFO, this adjusts the
intensity.
When the cutoff frequency is set to be controlled by the ENV, this adjusts the
intensity.
Adjusts the attack time.
Adjusts the decay time.
Adjusts the sustain level.
Adjusts the release time.
Adjusts the delay volume.
Adjusts the volume of the reverb.
Panel descriptions
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents